AN FPGA-BASED HARDWARE ACCELERATOR DATA SYNCHRONIZATION FROM DIGITAL RECEIVERS
132 viewsKeywords:
FPGA; FPGA-based Accelerator; Parallel processing; Pipelined architecture.Abstract
At present, the integrated density on digital integrated circuits has reached billions of transistors on a single chip, allowing the creation of dedicated hardware devices to accelerate the data processing, analysis, and searching of the large stream-based input data. The problem of processing big data obtained from digital receivers often encounters noise interference and phase deviation, leading to the need to analyze and rearrange them in the correct order for the next processing stages. If performed on software, these works are often inefficient because the processing speed does not meet the requirements. This paper proposes a searching and processing accelerator design for large stream-based data obtained from digital receivers, using a combination of parallel processing algorithms and pipeline techniques; conducts evaluations of the factors affecting the searching speed, and utilized resources to come up with the optimal design solution. We implemented the design on the Kintex 7-XC7K325T FPGA board for parallel data searching with a pattern length of 128 bits, using up to 512 comparison blocks at 100 MHz clock frequency and different modulation types such as PSK and QAM. Hardware performance is about 945 times faster than on the software with a maximum bandwidth of 800 Mbps.
References
[1]. Tien Manh Nguyen, “Phase-Ambiguity Resolution for QPSK Modulation Systems,” JPL Publication 89-4 (1989).
[2]. Sadchenko, O. Kushnirenko, “QPSK-Modulation Modem Invariant to the Rotation of the Signal Constellation Plane”, Electrical, Control and Communication Engineering, vol. 14, no. 2 (2018), pp. 149–156.
[3]. E. Kabalci et al, “Modelling and Analysis of a Power Line Communication System With QPSK Modem for Renewable Smart Grids”, International Journal of Electrical Power & Energy Systems, vol. 34, no. 1, pp. 19–28, Jan. 2012.
[4]. M. Mukesh et al, “QPSK Modulator and Demodulator Using FPGA for SDR,” International. Journal of Engineering Research and Applications, vol. 4, no. 4 (2014), pp. 394–397.
[5]. N. F. Huang et al, “A GPU-based Multiple-Pattern Matching Algorithm for Network Intrusion Detection Systems,” Proc. 22nd International Conference on Advanced Information Networking and Applications (AINA) (2008), pp. 62–67.
[6]. T. N. Thinh et al, “A FPGA-based deep packet inspection engine for Network Intrusion Detection System,” 9th International Conference on Electrical Engineering/Electronics, Computer, Telecommunications and Information Technology, Phetchaburi (2012), pp. 1-4.
[7]. Fiessler et al, “HyPaFilter+: Enhanced Hybrid Packet Filtering Using Hardware Assisted Classification and Header Space Analysis,” IEEE/ACM Transactions on Networking, Vol. 25 (2017), pp. 3655-3669.
[8]. F. Wang et al, “Research on Regular Expression Data Packet Matching Algorithm Based on Three State Content Addressable Memory,” International Journal of Simulation - Systems, Science and Technology, Vol. 16 (5A) (2015), pp. 8.1-8.5.
[9]. R. Clark et al, “A hardware platform for network intrusion detection and prevention”, Proc. of Workshop on Network Processors and Applications (2005), pp. 136–145.
[10]. P. Benácek et al, “P4-to-VHDL: Automatic Generation of 100 Gbps Packet Parsers,” Proc. IEEE 24th Annual International Symposium on Field-Programmable Custom Computing Machines (2016).
