Research on high-precision processing techniques of Nd-phosphate glass laser rods
DOI:
https://doi.org/10.54939/1859-1043.j.mst.208.2025.113-121Keywords:
Glass laser rod; Raw glass laser; Glass shaping; Glass grinding; Glass polishing; Optical testing.Abstract
This research presents techniques for fabricating cylindrical laser rods from raw glass using specialized glass cutting, grinding, and polishing machines. A square-cross-section glass rod, cut from a raw glass, is first transformed into an octagonal cross-section by grinding off its four corners. The octagonal rod is then processed into a circular cross-section using a precision cylindrical glass grinder. To polish the end faces of the glass rods, a dedicated holder was designed to securely hold the rods during processing. The fabricated laser rods were then inspected using specialized optical measurement instruments to ensure the highest machining accuracy. The inspection results show that the proposed fabrication method can produce laser rods with a perpendicularity deviation to the cylindrical axis of up to 3 arcminutes, an end-face parallelism deviation of 7.5 arcseconds, and a surface figure error as low as 0.042λ. These parameters are 3–4 times smaller than the standard quality requirements for laser rods, demonstrating that this method can achieve superior quality suitable for high-precision or specialized laser applications.
References
[1]. M. Yammane, Y. Asahara, “Glasses for photonics”, Cambridge University Press, 1st ed., p. 30, Cambridge, UK, (2000).
[2]. G. W. Fynn, W. J. A. Powell, “The cutting and polishing of electro-optic materials”, Adam Hilger, 2nd ed., pp. 64–74, 170–181, Bristol and Philadelphia, (1988).
[3]. W. L. Bond, “Making crystal elements for optical maser”, Review of Scientific Instruments, Vol. 33, No. 3, pp. 372–375, (1962).
[4]. G. A. Bennett, R. B. Wilson, “Precise polishing technique for optics and microwave acoustics”, Journal of Scientific Instruments, Vol. 43, pp. 669–670, (1966).
[5]. P. P. Hed, “Laser rod holder during grinding and polishing”, Applied Optics, Vol. 21, No. 9, pp. 1539–1540, (1982).
[6]. S. Chatterjee, “Simple technique for polishing laser rods”, Centre for Advanced Technology, Department of Atomic Energy, Government of India, (2002).
[7]. S. Chatterjee, Y. Pavan Kumar, “Simple technique for fabrication of Nd-phosphate laser glass rods for high power lasers”, Journal of Optics, Vol. 41, No. 4, pp. 187–197, (2012).
[8]. D. J. Dentz, “Manufacturing methods and technology engineering for batch processing neodymium-doped YAG laser rods”, US Army Electronics R&D Command, Night Vision & Electro-Optics Laboratory, (1980).
[9]. M. V. Mantravadi, D. Malacara, “Newton, Fizeau and Haidinger interferometers”, in Optical Shop Testing, D. Malacara (Ed.), Wiley, pp. 23–25, (2007).
[10]. G. A. Bennett, R. B. Wilson, “Precision polishing technique for optics and microwave acoustics”, Department of Electrical Engineering, University of Glasgow, Technical Report, (1966).
[11]. H. H. Karow, “Fabrication methods for precision optics”, John Wiley & Sons, 1st ed., pp. 704–721, New York, (2004).
